Roland S-1 Owner's Manual page 30

Creating sounds
Parameter Value Explanation
1.0–32.0
You can synchronize the waveform you created with the ForN parameter to a single wavelength while
increasing the playback speed (pitch) to generate sound.
With a 1.0 value, the waveform you created is as long as a single wavelength.
The larger the value, the more that the waveform gradually begins repeating from both sides within a
single wavelength, while the playback speed (pitch) of the waveform you created increases.
Each time the setting value is increased from 2.0, 4.0, 8.0, 16.0, and 32.0 increases the pitch by one
octave.
With higher note frequencies, increasing the Multiply value too much may cause noise.
If this happens, reduce the Multiply value or play the note at a lower octave.
1.0
NULt
1.5
(Multiply)
2.0
You can also edit the value by turning the OSCILLATOR [
holding down the [SHIFT] button.
30
(square wave level)] knob while