Editing With The Keyboard Pads (Chord) - Roland S-1 Owner's Manual

Editing the notes, performance data and motions

Editing with the keyboard pads (chord)

1. Press the [STEP] button to make it go dark, and press the [ó] (REC) button to make it light up.
The button toggles between lit and unlit each time you press it.
The step number appears on the display.
2. Use the [TEMPO/VALUE] knob to select the step to edit.
3. Press the note on the keyboard pad corresponding to the note you want to play, to make it light up.
The buttons toggle between lit and unlit each time you press them, and you can input and delete notes.
You can play up to four notes at the same time.
Editing the performance data (Ver. 1.02)
1. Hold down the keyboard pad of the note that contains the performance data you want to change, and
press the [D-MOTION] button to select the performance data to edit.
When you long-press a keyboard pad, the performance data inputted to that note is shown in the display.
Each time you press the [D-MOTION] button while holding down a keyboard pad, the display switches in the following order.
Keep holding down the keyboard pad to edit its value.
Item Display Explanation
Sets the velocity.
v. 1 00
Velocity
Setting range: 1–127
Sets the gate time (note length).
G. $ 80
Gate When this is set to 100 and the same note number has been input for the next step, a tie is played.
Setting range: 1–100
2. While holding down the keyboard pad, use the [TEMPO/VALUE] knob to edit the setting.
Inputting a tie (Ver. 1.02)
1. To input a tie that extends to the next step, press the [HOLD] button while holding down the keyboard
pad of the note whose length you wish to change.
After the tie is inputted, the unit automatically advances to the next step and the step number is shown in the display.
You can't input a tie if the same note already exists in the next step.
Deleting all notes at once within a specified step
1. Hold down the [SHIFT] button and press pad [11] (CLEAR NOTE).
"CLr. n " blinks in the display, and the unit waits for you to execute or cancel.
2. To execute, press pad [2] (ENTER).
If you decide to cancel, press pad [1] (EXIT).
Inputting a motion into a specified step
1. Use the [TEMPO/VALUE] knob to select the step to edit.
2. Turn the knob to register a motion.
"FULL" is indicated if the number of parameters exceeds the maximum number that can be registered in a motion.
If this happens, follow the steps in "Deleting all motions from a specified step at once" to delete any unnecessary motions.
Deleting all motions from a specified step at once
1. Use the [TEMPO/VALUE] knob to select the step to edit.
2. Hold down the [SHIFT] button and press pad [12] (CLEAR MOTION).
"CLr. N " blinks in the display, and the unit waits for you to execute or cancel.
36