Advertisement
Problem
There is no water on the
floor.
There is more water on the
floor or in the After-Clean
tray than usual.
The appliance leaves water
traces on the floor.
Possible cause
The clean water tank is empty.
The wetting strips are blocked.
The water channel of the wet
module and/or AquaSpin
nozzle is polluted or blocked.
The dirty water tank is not
placed correctly.
You have moved the appliance
sideways.
You made strong turns with
the appliance.
You have moved the appliance
across a threshold while it was
switched on.
You lifted the appliance up
from the floor immediately
after you switched it off.
Solution
Refill the clean water tank.
Remove the two microfiber brushes, fill the
clean water tank with some water, and
switch the appliance on. Make small
forward and backward movements on the
same position for around 15 seconds. You
should be able to see four water stripes on
the floor. If this is not the case, or if one or
more water stripes only consist out of a few
droplets, the wetting strips are partially or
fully blocked and you can rinse them under
the tap. If that does not help, you can try to
carefully open the holes with a needle.
If you have checked the above and there is
still no water on the floor, take the
appliance to a Philips service center or
contact the Consumer Care Center.
Use the cleaning brush and clean the water
channel of the wet module and/or
AquaSpin nozzle (see 'Removing blockages
from the appliance').
Place the dirty water tank into the
appliance properly. It is closed correctly
when you can hear a 'click' sound.
Only move the appliance forwards and
backwards.
Try to make less strong turns with the
appliance.
Make sure the microfiber brushes stay in
contact with the floor. Make sure water
absorption mode
is switched on before
you lift the appliance over a threshold,
carpet or stairs to prevent water traces on
the floor or to prevent water from
splashing from the AquaSpin nozzle.
Switch on water absorption mode
absorb remaining water. Move the
appliance forwards and backwards a few
times with water absorption mode
engaged before switching it off If you
switch off the appliance and lift it up
immediately afterwards, the water that was
present between the brushes leaves a trace
of water on the floor.
English
25
to
Advertisement
