Advertisement
English
24
Problem
The appliance stopped
working.
The floor is less wet than
usual, or one side of the floor
under the nozzle is less wet
than the other one.
Possible cause
You did not take the appliance
out of the After-Clean &
Storage station.
You pushed the on/off
button more than one time.
The appliance is clogged.
The microfiber brushes are
stuck.
You accidentally touched the
on/off
button with your
hand.
The dirty water tank may be
full. In this case, there is an
information icon shown on the
screen (see 'Display icons and
their meaning').
The appliance is clogged.
One or both wetting strips may
be blocked.
Solution
Take the appliance out of the After-Clean &
Storage station before switching on the
appliance.
Wait a few seconds and push the on/off
button again one more time.
Switch off the appliance. Then locate and
remove the cause of the blockage (see
'Removing blockages from the appliance').
After that, restart the appliance. If you
cannot identify the cause of the blockage,
restart the appliance. This might already
solve the problem.
Take the microfiber brushes out. Then
locate and remove the cause of the
blockage in the microfiber brushes. Then
Place the microfiber brushes back (see
'Cleaning the AquaSpin nozzle').
Tip: In case a microfiber brush is difficult
to remove, you can use the cleaning brush
handle to unlock the microfiber brush.
Switch on the appliance by pushing the
on/off
button.
Empty the dirty water tank.
Switch off the appliance. Then locate and
remove the cause of the blockage (see
'Removing blockages from the appliance').
After that, restart the appliance. If you do
not identify the cause for the blockage, just
restart the appliance. This might already
solve the problem.
Remove the two microfiber brushes, fill
some water into the clean water tank and
switch the appliance on. Make small
forward and backward movements on the
same position for around 15 seconds. You
should be able to see four water stripes on
the floor. If this is not the case, or if one or
more water stripes only consist out of a few
droplets, the wetting strips are partially or
fully blocked and you can rinse them under
the tap. If that does not help, you can try to
carefully open the holes with a needle.
Advertisement
