English
18
23 Turn the microfiber brushes counterclockwise (1) and remove them from the
AquaSpin nozzle (2).
Tip: In case a microfiber brush is difficult to remove, you can use the
cleaning brush handle to unlock the microfiber brush.
24 To allow the microfiber brushes to dry, place the open ends of the brushes on
the designated holders of the After-Clean & Storage station.
Note: Drying can take approximately 24 hours.
Cleaning the After-Clean tray
If the After-Clean tray gets dirty, you can clean it by following the steps below.
1 Remove the After-Clean tray from the storage station.
2 Rinse the After-Clean tray under the tap and let it dry before placing it back in
the Storage station.
3 Make sure to always put the After-Clean tray back in the Storage station. The
After-Clean tray is essential to perform the AUTOCLEAN correctly.