Resetting The Csacs 1120 Cli Administrator Name - Cisco 1120 Installation Manual

Reconfiguring CSACS 1120 System Parameters
To reset the ACS administrator login credentials:
Log in to the CSACS 1120. For more information, see
Step 1
Console.
At the system prompt, enter
Step 2
At the
Step 3
At the
Step 4
At the
Step 5
Note
Step 6 At the
Result: The console displays:
Password is set successfully.
Administrator account name is set to ____

Resetting the CSACS 1120 CLI Administrator Name

There is always a single set of ACS CLI administrator credentials that consists of the administrator name
and password. Unlike other ACS administrative accounts, this unique administrative account is granted
all privileges, cannot be deleted, and is not listed in the Administrators table of the Administrative
Control page in the ACS web interface.
You can reset the ACS CLI administrator name, the administrator password, or both. This procedure
details how to reset the administrator name after you log in with the existing credentials. To reset the
password, see
The CLI administrator login does not provide access to the CSACS 1120 using the web GUI. You must
Note
set up an initial web GUI password using the add guiadmin command. For information on setting up an
initial web GUI account, see
If you do not have the existing CLI administrator login credentials, you must use the recovery CD-ROM
to reset these credentials. For information on resetting the administrator login and password without first
logging on, see
To reset the ACS CLI administrator name:
Log in to the CSACS 1120 . For more information, see
Step 1
Console.
At the system prompt, enter
Step 2
Installation Guide for the Cisco 1120 Secure Access Control Server 4.2
4-18
set password
prompt, enter the old password, and press Enter.
Enter old password:
Enter new account name:
prompt, enter the new password, and press Enter.
Enter new password:
The new password must be unique and should not be identical to the last ten passwords that have
been used. It must not contain the administrator account name, must contain a minimum of six
characters, and it must include a mix of at least three character types: numerals, special
characters, uppercase letters, and lowercase letters. Each of the following examples is
acceptable: 1PaSsWoRd, *password44, Pass*word.
Renter new password again:
Resetting the CSACS 1120 Administrator
Resetting the GUI Administrator Login and
Recovering from Loss of Administrator
set admin
Chapter 4 Administering the Cisco 1120 Secure Access Control Server
Logging In to the CSACS 1120 from a Serial
, and press Enter.
prompt, enter the new account name, and press Enter.
prompt, reenter the new password, and press Enter.
Password.
Credentials.
Logging In to the CSACS 1120 from a Serial
, and press Enter.
Password.
OL-19455-01