Reimaging The Csacs 1120 With The Acs 4.2 Recovery Dvd; Restoring The Acs Se 4.1.1.24 Configuration - Cisco 1120 Installation Manual

Chapter 5 Upgrading and Migrating to Cisco 1120 Secure Access Control Server
Step 10 Restore the data that you previously backed up in
•
•
Step 11 Verify that CSAgent is enabled by using one of the following features:
•
•

Reimaging the CSACS 1120 with the ACS 4.2 Recovery DVD

This section describes the procedure of reimaging the appliance using the ACS 4.2 Recovery DVD.
To re-image the appliance:
Obtain the ACS 4.2 Recovery DVD.
Step 1
Insert the ACS 4.2 Recovery DVD into the DVD drive and reboot the CSACS 1120.
Step 2
Result: The console displays:
ACS Appliance Recovery Options
[1] Reset administrator account
[2] Restore hard disk image from CD
[3] Exit and reboot
Enter menu item number: [ ]
From the list of options on the screen, enter
Step 3
The re-image process begins automatically.
This process may take a few minutes. Once the re-image process is complete, the console displays:
Step 4
Remove disk and press enter.
Remove the ACS 4.2 Recovery DVD and press Enter.
Step 5
The CSACS 1120 reboots and the initial configuration screen appears.
Configure the CSACS 1120 by following the steps provided in the section,
Step 6
CSACS

Restoring the ACS SE 4.1.1.24 Configuration

This section describes the procedure for restoring the ACS SE 4.1.1.24 configuration in the appliance
after installing ACS SE 4.2.
To restore the ACS SE 4.1.1.24 configuration:
Log in as the GUI administrator.
Step 1
In the navigation bar, click System Configuration.
Step 2
OL-19455-01
ACS Restore, which is available in the System Configuration section of the web interface. For more
information, see the latest version of the User Guide for Cisco Secure ACS 4.2.
The restore command, which you enter from the serial console. For more information, see
Restoring ACS Data from the Serial
At the console, enter
show
In the web interface, choose System Configuration > Appliance Configuration and verify that the
CSA Enabled check box is checked. If not, check it and click Submit.
1120".
Step 7
Console.
. If the CSAgent service is not running, enter
in the
two Enter menu item number: [ ]
Installation Guide for the Cisco 1120 Secure Access Control Server 4.2
by using one of the following features:
start csagent
Chapter 3, "Configuring
Upgrade Procedure
.
: prompt.
5-11