Setting Up Of The Perimeter Wire; Setup Of The Robot's Quick Re-Entry To The Charging Station - Stiga Autoclip M7 Operator's Manual

Robot lawn mower

Hide thumbs Also See for Autoclip M7:

Quick start manual (4 pages)

Quick start manual (4 pages)

Table Of Contents

Table of Contents

Before installing the perimeter wire, it is necessary to check the

entire surface of the lawn. Make any necessary adjustments to the

grassy surface during the laying of the perimeter wire in order to

allow the robot to function correctly.

1. Evaluate whether a special installation of the perimeter wire

is necessary according to the instructions described in the

chapter "SET-UP OF THE ROBOT'S QUICK RE-ENTRY TO

THE CHARGING STATION".

2. Preparation and defining of the work areas.

3. Installation of the perimeter wire.

4. Installation of the charging station and power supply unit. When

laying the perimeter wire, respect the installation direction

(clockwise) and the rotation direction around the flowerbeds

(counter-clockwise), As shown in the figure.

SETUP OF THE ROBOT'S QUICK RE-ENTRY TO THE CHARGING STATION

(Only for some models, see "Technical Specifications"). Quick re-entry requires a special installation of the perimeter wire that

allows the robot to reduce the re-entry path to the charging station. This special installation of the perimeter wire should only be

used for gardens where quick re-entry significantly reduces the path and where the perimeter length is greater than 200 meters.

To setup the quick re-entry, position the perimeter wire on the ground so that it forms a triangle with one side of 50 cm (19.7 ")

and the other two sides of 40 cm (15.75 ") each, as shown in the figure.

As the robot heads back to the charging station with the two wheels on either side of the wire, it intercepts this triangle and stops

moving. It then turns approximately 90° towards the inside of the garden and starts moving in the new direction until running into

the perimeter wire on the opposite side.

Arrange the wire for quick re-entry in a point where there is at least 200 cm (78.74 ") of straight wire in front of the station, and

at least 150 cm (59.05 ") of straight wire behind it.

Do not set up the wire along the straight section immediately in front of the charging station or near any obstacles. Make sure

there are no obstacles along the re-entry path that may obstruct the quick re-entry.

Do not set up the wire along excessive slope, so that the robot can recognizes easy it. The maximum slope depends on the lawn

conditions. It should be remain under approximately 20%.

Important

An incorrect setup of the robot's quick re-entry may prevent the robot from returning to the charging station

quickly. When the robot travels along the perimeter to reach a secondary area, it may not detect the quick

re-entry setup.

The illustration provides some useful tips on how to correctly setup

the robot for a quick re-entry.