Barrel Removal
1. Remove the retaining nut (1), tip guard, (12), air
cap (15), spray tip (13), and gun shroud (2) as
instructed on page 31.
2. Disconnect the bottom fluid tube nut (C). See
Fig. 34 .
3. Remove the jam nut (8) and actuator arm (19).
4. Loosen the three screws (24) with the ball end
wrench (77), supplied. See Fig. 35 .
26
Fig. 34
Fig. 35
Service
5. Hold the gun body (29) with one hand and pull the
barrel (26) straight away from the body to remove
it. See Fig. 36 .
To avoid damaging the power supply (27), always
pull the gun barrel straight away. If necessary, gen-
tly move the gun barrel from side to side to free it
from the gun handle.
8
19
77
24
Fig. 36
CAUTION
C
27
29
26
29