Table of Contents
Advertisement
Install P-trap and the L-shaped fitting from foot mounting kit.
Secure the L-shaped fitting to the ground by 2 sets of bolts or
screws (not supplied).
Insert P-trap into the wall outlet, secure to the ground by 2
sets of bolts or screws (not supplied).
NOTE:
The sealing ring of P-trap outlet must be fully inserted
into the wall pipe.
The horizontal deviation between the center of P-trap
outlet and the center of wall outlet should not exceed
10mm to the left or right.
Ensure that the above requirements are complied
with to prevent water leakage.
Floor Mounting Kit
INSTALL THE TANK
(For K-29216T-NS)
Carefully turn the tank upside down
onto a protected surface. Fit the tank
gasket over the flush valve nut.
Carefully position the tank on the bowl
by centering the gasket on the bowl
inlet. Align the tank with the bolt hole
on the bowl.
INSTALL THE TANK
(For K-29216T-HC)
Carefully turn the tank upside down
onto a protected surface. Fit the rubber
gasket over the flush valve nut.
Carefully position the tank on the bowl
by centering the gasket on the bowl
inlet. Line up the tank and bowl bolt
holes.
The hook, which is outside the front of
the bowl , is for arranging the inlet pipe
and wire of the electronic seat.
CAUTION: Risk of product
damage. Overtightening may
cause breakage or chipping of
the vitreous china.
Assemble the washers and nuts to the
tank bolts. Securely tighten the nuts so
the tank is level.
Be sure the nuts are tight enough to
achieve a watertight seal.
1505361-T2-A
Fig.#6
6
Tank Bolt
Gasket
Tank
Bowl
Washer
Brass Nut
Tank Bolt
Gasket
Tank Bolt
Gasket
Tank
Bowl
Washer
Fig.#9
Brass Nut
Viewing The
Assembly From
Under The Tank
Fig.#10
-4-
L
L
2
(
)
Tank
(
Tank Gasket
Bowl
Fig.#8
8
(
Tank
Bowl
Hook
Brass Nut
9
Tank
10
L
2
10mm.
Fig.#7
7
K-29216T-NS)
K-29216T-HC)
Advertisement
Table of Contents
