Install The Tank - Kohler K-3519 Installation Manual

Tank Bolt
Rubber
Spacer

3. Install the Tank

CAUTION: Risk of product damage. Handle with care.
Vitreous china can break or chip if the bolts and nuts are
overtightened, or if the product is handled carelessly.
NOTE: Do not remove the pre-assembled tank bolts from the bottom
of the tank. The nuts and washers for securing the tank to the bowl
are packaged separately.
Verify that the factory installed rubber spacers are in place on the
tank bolts.
Position the tank on the bowl by centering the gasket on the bowl
inlet.
Assemble the washers and nuts to the tank bolts.
Tighten the nuts until snug. Do not overtighten the nuts.
Verify that the tank is level both left to right and front to back.
Make sure the nuts are tight enough to achieve a watertight seal.
Kohler Co.
Gasket
5 1054184-2-B