Panasonic Panaboard UB-8325 Operating Instructions Manual page 76

Daily Care and Maintenance
2
Clean the Printer Head
Dampen the tip of a cotton-tipped swab in ethyl
alcohol and gently wipe the printer head.
Note
• Never touch the printer head or the
surrounding area with your hands as this may
disable copying.
3
Clean the Platen Roller and the
Pick-up Roller
Remove the thermal transfer film with both
hands and carefully wipe any dirt or stains off
the platen roller and pick-up roller.
• For details on removing the thermal transfer
film, see page 22.
• Dampen a soft cloth with neutral kitchen
cleaner diluted in water, wring the cloth
thoroughly, and wipe the entire surface of the
rollers while rotating them. If this does not
remove all dirt, wipe with a cloth dampened
with ethyl alcohol.
76
Cotton-tipped swab
Printer head
(Gold)
Pick-up roller
Platen roller
4
Install the thermal transfer film in its original
position and close the printer door.
Latches
• For details on installing the thermal transfer
film, see pages 18.
• Close the printer door firmly until a click is
heard.
Note
• If "
" is still flashing after closing the printer
door, make sure that the thermal transfer film
has been installed properly and tightened.
• The printer door should be closed to make
copies properly. Confirm both latches are
locked.