Output Settings
USB
Here's how to configure the USB output settings.
USB MAIN
This is the main output for USB. The same audio as the audio
output from the MAIN OUT jacks is outputted.
EQ
1 .
Touch <EQ>.
2 .
Tap the EQ button to turn it ON (the button lights up
green).
3 .
Adjust the tonal character of each frequency band.
* For details on the parameters, refer to "Parameter Guide" (Roland
website).
GENERAL
1 .
Touch <GENERAL>.
2 .
Set the parameters.
Parameter
Explanation
LEVEL
Sets the signal output level.
MONO MIX
Switches the signal output from USB to mono.
28
USB MONITOR
This is the monitor output for USB. The same signal is output as
that which is output from the headphones 1, 2 jacks.
You can also use your computer to listen to the audio that you can
hear from the headphone jacks of the GCS-5, by specifying the
channel for conversation or chats.
EQ
1 .
Touch <EQ>.
2 .
Tap the EQ button to turn it ON (the button lights up
green).
3 .
Adjust the tonal character of each frequency band.
* For details on the parameters, refer to "Parameter Guide" (Roland
website).
GENERAL
1 .
Touch <GENERAL>.
2 .
Set the parameters.
Parameter
Explanation
LEVEL
Sets the signal output level.
MONO MIX
Switches the signal output from USB to mono.