Kohler K-702 Installation Manual page 2

Important Information
WARNING: When using electrical products, basic
precautions should always be followed, including
the following:
DANGER: Risk of electric shock. Connect only to a
circuit protected by a Ground-Fault
Circuit-Interrupter (GFCI) or Earth-Leakage
Circuit-Breaker (ELCB).
Building materials and wiring should be routed away from the
pump body and other heat-producing components of the unit.
Install to permit access for servicing.
A pressure wire connector marked "Earth/Ground" is provided
within the wiring compartment. To reduce the risk of electric
shock, connect this connector to the grounding terminal of your
electric service or supply panel with copper wire equivalent in
size to the circuit conductor supplying this equipment.
Pressure wire connectors are provided on the exterior of the
junction box or control within this unit to permit connection of a
bonding conductor between this unit and all other exposed
metal in the vicinity, as needed to comply with local
requirements.
Grounding is required. The unit should be installed by a
qualified service representative, and grounded.
Electrical Requirements
The installation must have a Class A Ground-Fault
Circuit-Interrupter (GFCI) or Earth-Leakage Circuit-Breaker
(ELCB). The GFCI or ELCB protects against line-to-ground
shock hazard. Use a 220/240 V, 20 A, 50/60 Hz dedicated
service for the whirlpool.
A
1018963-2-
Product Notices
WARNING: Unauthorized modification may
cause unsafe operation and poor
performance of the whirlpool. Do not relocate
the whirlpool pump, or make other
modifications to the whirlpool system, as this
could adversely affect the performance and
safe operation of the whirlpool. Kohler Co.
shall not be liable, under its warranty or
otherwise, for personal injury or damage
caused by any such unauthorized
modification.
WARNING: Risk of electric shock. A licensed
electrician should make all electrical
connections.
WARNING: Risk of electric shock.
Disconnect power before servicing.
WARNING: Risk of injury or property
damage. Please read all instructions
thoroughly before beginning installation,
including the following requirements.
NOTICE: Follow all local plumbing and electrical
codes.
Features
"-N1" Series: Components include a pump, heater,
control, shut-off valve, neckjets, pulse cannister and
illuminated switch (user keypad).
"-H2" Series: Components include a pump, heater,
control and illuminated switch (user keypad).
The whirlpool pump and piping are factory-assembled.
Connections and Service Access
Before installation, ensure proper access to the final
connections.
NOTICE: Provide generous, unrestricted service
access to the pump. You must provide access for
servicing the pump and controls. The access must be
located immediately next to the pump. Study the
roughing-in information packed with the whirlpool.
2
Kohler Co.