Table of Contents
Advertisement
Operations
General (cont.)
Problem
Whenever I try to retrieve my
voice mail messages, the
retrieval is interrupted by the
fax tone.
Fax – sending
Problem
I cannot send documents.
The other party complains that
letters on their received
document are distorted or not
clear.
The other party complains that
dirty patterns or black lines
appear on their received
document.
I cannot send a fax overseas.
Fax – receiving
Problem
I cannot receive documents.
I cannot receive documents
automatically.
60
You are probably entering
messages.
code. If you use a voice mail service, set the fax activation
feature to off or reprogram the activation code (feature #41
on page 54).
The telephone line cord is connected to the EXT jack on
the unit. Connect to the LINE jack (p. 14).
The other party's fax machine is busy or has run out of
recording paper. Try again.
The other party's machine is not a facsimile. Check with
the other party.
The other party's fax machine rings too many times. Send
the fax manually – dial the number, confirm the fax tone,
then press
If your line has special telephone services such as call
waiting, the service may have been activated during fax
transmission. Connect the unit to a line that does not have
these services.
The extension telephone on the same line is off the hook.
Hang up the extension telephone and try again.
Try copying the document. If the copied image is clear,
there may be something wrong with the other party's
machine.
The glass or rollers are dirty. Clean them (p. 68).
Use the overseas transmission mode of feature #23 (p. 52).
Add two pauses at the end of the telephone number or
dial manually.
The telephone line cord is connected to the EXT jack on
the unit. Connect to the LINE jack (p. 14).
The receive mode is set to TEL mode. Set to FAX ONLY
mode (p. 39) or TEL/FAX mode (p. 40).
The time taken to answer the call is too long. Decrease
the number of rings of features #06 (p. 50), #30 (p. 53)
and #78 (p. 55).
For fax advantage assistance, call 1-800-435-7329.
Cause & solution
98 or
9 is the default setting for the fax activation
Cause & solution
FAX START
.
Cause & solution
99 to retrieve your
(continued)
Advertisement
Table of Contents
