Vsl: Channel Tab; Loading Scenes And Presets From Vsl - PRESONUS StudioLive 16.0.2 Owner's Manual

7 Software: Universal Control, SL Remote, Capture & Studio One Artist
7.2 VSL: Virtual StudioLive
is also updated. If you use your mouse to adjust a parameter in VSL,
the StudioLive will be updated remotely. It is important to remember
that every button, knob, slider, and fader on the VSL corresponds
directly to a button, knob, slider, or fader on your StudioLive.
The graphic above identifies each controller, labeled with its
corresponding control on the StudioLive, and can be used as
a map to quickly learn how to navigate the Overview tab.
Aux Send View
7.2.3

VSL: Channel Tab

The Channel tab provides a detailed overview of the Fat Channel
parameters for the selected channel. The selected channel will always
be shown above the Gate section. It is important to remember
that you have continuous bidirectional control. If you wish to
grab a point in the EQ with your mouse, for example, you will be
changing the parameters both in VSL and on your StudioLive.
To access the Fat Channel for FXA and FXB, you will need to press
its Select button on the StudioLive. You can then load presets and
make adjustments using VSL from within the Channel tab.
70 70
PreSonus StudioLive ™ 16.0.2
VSL provides two views for your StudioLive Aux
outputs and FX buses. The Aux Send View gives you an
overview of the send levels of every channel on your
StudioLive to every Aux output and FX bus.
To quickly set up an Aux mix, use your mouse to
set the send level for Channel 1. Right-click on the
Channel 1 send level and sweep your mouse across
the other channel sends for that Aux. The send level
will be copied to every other channel for that Aux.
Owner's Manual
Software: Universal Control, SL Remote, Capture & Studio One Artist
7.2.4

Loading Scenes and Presets from VSL

As stated in the previous section, the Browser window in VSL
functions much in the same way as the Browser in Studio One.
This means that to load a Scene or preset from the Browser
window, you simply select it and drag it over the mixer or channel
on which you wish to load it. Scenes and presets can be dragged
from either the On Disk or the Device Memory section of the
Browser and dropped onto the Overview or the Channel tab.
Loading a Scene
To load a new Scene on your StudioLive, select it from the Browser
window and drag it over the mixer in either the Overview or the Channel
tab. The window will gray out indicating that a new Scene is about to be
loaded. Please note: Only the parameters that have been enabled for
recall on the StudioLive will be recalled on the mixer.
See Section 5.1 for more details.
Loading Scribble Strip Labels
Scribble Strip labels are stored with your Scenes. You can load just the
labels by selecting the Scene from the Browser window and dragging it
over the row of Scribble Strips above the Channel Faders. The Scribble
Strips will gray out, indicating that the Scribble Strip labels from the
Scene are about to be loaded.
Loading an Entire Fat Channel Preset
To load every component in a Fat Channel preset (Gate, Compressor, EQ),
select it from the Browser window and drag it over any part of the desired
channel. If you drag it over any of the component Quick Views, it will load
only that component; for example, if you drag a preset over the Gate
Quick View, only the Gate will be loaded.
7
VSL: Virtual StudioLive 7.2
71 71