Appendix A: Integration And Usage Tips - Intel SR2612UR Product Specification

Intel® Server System SR2612UR TPS

Appendix A: Integration and Usage Tips

This section provides a list of useful information unique to the Intel
and should be kept in mind while integrating and configuring your Intel

Only low-profile (1.2 in or 30.48 mm) DIMMs can be used in the server system.

Processor fans are not supported and are not needed in the server system. The system
fan module and power supply fans provide the necessary cooling needed for the system.
Using a processor fan in this system may cause Intel
incorrectly monitor the system fans.

The CPU air duct must be used to maintain system thermals.

To maintain system thermals, all hard drive bays must be populated with either a hard
drive or drive blank.

System fans are not hot-swappable

Use of the screw found on the back edge of the top cover is required when the unit is
installed in a user-accessible environment.

The FRUSDR utility must be run to load the proper Sensor Data Records for the server
chassis onto the server board.

Make sure the latest system software is loaded on the server. This includes system
BIOS, FRUSDR, Integrated BMC firmware, and hot-swap controller firmware. You can
download the latest system software from the following website:
http://support.intel.com/support/motherboards/server/s5520ur/
Revision 1.3
Intel order number E76293-003
Appendix A: Integration and Usage Tips
®
Server System SR2612UR
®
Server Board S5520UR.
®
System Management Software to
61