Status Display - Panasonic KX-P8410 Operating Instructions Manual

Status Display

Error message
ASPI for Win 16 or 32
could not properly
initialize itself. This may
be caused by a lack of
system resources.
Invalid LPT Port.
Load Library Error!,
File Open Error! or
Install Error! appears
and Status Display does
not appear.
No ASPI managers are
loaded. This typically
occurs when a DOS
ASPI manager is not
resident in memory.
Not Detect.
Care and Maintenance
Possible cause
Lack of system
resources, or other
trouble related to
SCSI.
Unavailable LPT port is
selected when using
Windows 3.1.
The necessary file is
not installed in the
computer.
SCSI board is not
correctly set.
BThe printer was
turned on after
turning on the
computer.
BThe terminator
setting is improper.
BSCSI setting or
cable connection is
improper.
Recovery
Close some application
and retry. For any other
trouble related to SCSI,
refer to the SCSI section of
Care and Maintenance
( P. 134).
Select the other available
LPT port by following the
procedure below.
1. Double click the Main
icon.
2. Double click the Control
Panel icon.
3. Double click the Printers
icon.
4. Click Connect... .
5. Click the other port, then
click OK.
6. Click Close.
Reinstall the KX-P8410
software.
Correctly set the SCSI
board in the computer.
(Refer to the manual of the
SCSI board.)
For any other trouble
related to SCSI, refer to
the SCSI section of Care
and Maintenance
( P. 134).
Turn off the printer and the
computer, then turn them
on again. If the trouble still
remains, confirm the
following points.
BThe terminator is
correctly set.
BThe SCSI board is
correctly installed in the
computer.
BThe system is correctly
connected with SCSI
cables.
BEach SCSI device has a
different ID Number.
149