Panasonic WV-NP1004 Network Operating Instructions page 34

Step 6
Select "ON" or "OFF" for "Light detection control".
When "ON" is selected, detection errors caused by turn-
ing lighting on/off can be diminished.
Notes:
• Complete prevention of detection error is not guar-
anteed even if using this function.
• When "ON" is selected, performance of the motion
detection may be lower.
Step 7
Click the [SET] button after completing the settings.
Important:
• The setting will not be applied unless the [SET] but-
ton is clicked.
• The VMD function refers differences between
MPEG-4 frames. When differences between frames
are many, a VMD alarm will occur. When differences
are very few, VMD alarm may not occur. Therefore,
when "1 sec" is selected for "Refresh interval" and a
small value is selected for "Max bit rate (per a
client)", VMD alarm occurrence may get fewer since
frames are frequently refreshed and differences
between the current frame and the previous frame
might be small.
Delete the set VMD area
Step 1
Click the [DEL] button respective to the area to be delet-
ed.
→ The outline of the area will disappear and the select-
ed area will be deleted.
34
Step 2
Click the [SET] button after completing settings.
→ The deletion will be completed.
Important:
The deletion will not be completed unless the [SET]
button is clicked.