Panasonic WV-NP1004 Network Operating Instructions page 31

Configure the settings relating to the alarm image [Alarm image setup]
Click the [Alarm] tab on the "Alarm setup" page. (☞ page 30)
The settings relating to the alarm image to be transmitted to the FTP server can be configured on this page. The
alarm image will be transmitted to the FTP server. To transmit alarm images to the FTP server, it is necessary to
configure the settings in advance. (☞ page 40)
The settings for image capture size and image quality on the "JPEG/MPEG-4" tab (☞ page 23) will be applied to
alarm images.
Refer to pages 30 and 32 for further information about the settings relating to the alarm action and the alarm out
connector.
[Alarm image FTP transmission]
Select "ON" or "OFF" to determine whether or not to
transmit the alarm image to the FTP server.
Default: OFF
[Directory]
Enter the directory name where the alarm images are to
be saved.
For example, enter "/ALARM" to designate the directory
"ALARM" under the FTP root directory.
Number of characters for the directory name:
0 - 256 characters
[File name]
Enter the file name used for the alarm image to be
transmitted to the FTP server. The file name will be as
follows.
["Entered file name" + "Time and date (year/month/day/
hour/minute/second)"] + "Serial number"
Number of characters for the file name: 1 - 8 charac-
ters
Default: (blank)
[Transmission interval]
Select the transmission interval for the alarm image FTP
transmission from the following.
0.1 fps/0.2 fps/0.33 fps/0.5 fps/1 fps
Default: 1 fps
[Number of images]
Select the number of images to be transmitted from the
following.
10 pics/20 pics/30 pics/50 pics/100 pics/200 pics/
300 pics/500 pics/1000 pics/2000 pics/3000 pics/
5000 pics
Default: 100 pics
[Recording duration]
Approximate time to be taken to save the set "number of
images" with the set "transmission interval" will be dis-
played.
[Image capture size]
Select an image capture size of images to be transmit-
ted to the FTP server from the following according to the
selected scan mode.
When "Full scan" is selected for the scan mode
1280 x 960/VGA/QVGA
When "Partial scan" is selected for the scan mode
960 x 720/VGA/QVGA
Default: VGA
31