General Instructions; Screws/Hardware - Kyocera Ecosys FS-600 Service Manual

General Instructions

This chapter provides procedures for removal and replacement of field
replacement components. For other components not shown in this chapter, the
diagrams in the
component.
For replacement of a component, use the reverse of the removal procedures
explained in this chapter.
Before proceeding, make sure printer power is switched off and the power cord is
unplugged from the printer. See Warning below.
Warning ——To avoid injury to human bodies, make sure that
AC power is removed and the power cord is unplugged from
both the power line and the printer.

Screws/hardware

Screws and hardware used in the printer are listed in the
Symbol numbers also given in the list for these screws are referred to in the
disassembling instructions in the following pages. These screw symbol numbers
are universal to most Ecosys printers.
Caution ——To secure a self-tapping screws, align it with the
thread carefully. First turn it counterclockwise, then slowly
clockwise. Do not over-tighten. In case the selftapped thread
is damaged, the affected part must be replaced with a new
part.
Parts catalog attached with this manual will help locate the
5-3
Disassembly
General Instructions
Ecosys screw catalog.
FS-600/FS-680