Getting The Process Unit Ready For Use - Kyocera Ecosys FS-600 Service Manual

Installation and operation
Installing the printer

Getting the process unit ready for use

The printer comes with the Process unit (PU-16) factory-installed inside. The Process unit
must once be taken out from the printer for a simple treatment that must be done before
use. To do this, proceed as follows.
Caution—The drum in the process unit is sensitive to light. Do not expose it even to normal
office lighting (500 lux) for more than five minutes.
Caution—Handle the process unit with care. Avoid impact on it. Do not touch the green or
blue surface of the drum in the process unit.
Open the top cover. Holding the Process unit like below, take the Process unit carefully out.
FS-600/FS-680
2-5