General Instructions; Screws/Hardware - Kyocera Ecosys FS-6700 Service Manual

5.1

General Instructions

This chapter provides procedures for removal and replacement of field replacement
components. For other components not shown in this chapter, the diagrams in the
Parts Catalog attached with this manual will help locate the component.
For replacement of a component, use the reverse of the removal procedures
explained in this chapter.
Before proceeding, make sure printer power is switched off and the power cord is
un-plugged from the printer. See Warning below.
Warning

Screws/hardware

Screws and hardware used in the printer are listed in the beginning section of the
Parts catalog. Symbol numbers also given in the list for these screws are referred
to in the disassembling instructions in the following pages.
Caution
To avoid injury to human bodies, make sure that AC power is removed
and the power cord is unplugged from both the power line and the
printer.
To secure a self-tapping screws, align it with the thread carefully. First
turn it counterclockwise, then slowly clockwise. Do not over-tighten.
In case the selftapped thread is damaged, the affected part must be
replaced with a new part.
5-2
Disassembly
General Instructions
FS-6700