Kyocera Ecosys FS-600 Service Manual page 2

FS-600/680 Service Manual
©Kyocera Corporation 1997—1999. All rights reserved. Export Edition
Notice
The information in this manual is subject to
change without notification. Additional
pages may be inserted in future editions.
The user is asked to excuse any technical
inaccuracies or typographical errors in the
present edition.
No responsibility is assumed if accidents
occur while the user is following the
instructions in this manual. No
responsibility is assumed for defects in the
printer's firmware.
The contents of this manual are protected
by copyright. No part of this manual may be
reproduced or copied by any means without
the permission of the copyright holder. The
printer's firmware (contents of its read-only
memory) is similarly protected by
copyright.
This Kyocera printer uses PeerlessPrint5 to
provide the HP LaserJet IV compatible
PCL5e language emulation. PeerlessPrint5
is a trademark of the Peerless Group,
Redondo Beach, CA 90278, U.S.A.
This product was developed using the
TM
Tornado Real Time Operating System
from Wind River Systems.
Trademark Notice
Prescribe is a registered trademark of
Kyocera Corporation. PRESCRIBE IIe,
KIR, Kyocera Image Refinement, Ecosys,
and Ecotone are trademarks of Kyocera
Corporation.
Diablo 630 is a product of Xerox
Corporation. IBM Proprinter X-24E is a
product of International Business Machine
Corporation. Epson LQ-850 is a product of
Seiko Epson Corporation. HP LaserJet 5Si
and HP-7475A are product of Hewlett-
Packard Company. Hewlett-Packard, PCL,
and HP-GL are registered trademarks of
Hewlett-Packard Company. Centronics is a
trade name of Centronics Data Computer
Corp.
Warning
This equipment has been certified to
comply with the limits for a Class B
computing device, pursuant to Subpart J of
Part 15 of FCC Rules. Only peripherals
(computer input/output devices, terminals,
etc.) certified to comply with the Class B
limits may be attached to this equipment.
Operation with non-certified peripherals is
likely to result in interference to radio and
TV reception.
Check that the cable is wired correctly. If an
IBM communication adapter cable type
1502067 is used, it will have to be
resoldered the wiring at the printer end of
the cable. The procedure is as follows.