Table of Contents
Advertisement
APPLICATION
This mixer is intended for the mixing of plaster and mortar
only. The mixer must be used for its intended purpose and
is not suitable for the mixing of flammable or explosive
substances. The mixer must not be used in an explosive
atmosphere.
The drum capacity of this mixer is 7 cubic feet (198 liters)
with a batch capacity of 1.5 to 2.5 bags. The mixer has
been factory tested and is shipped completely assembled,
ready for use.
POWER PLANT
The mixer is powered by a MPower 177F-BH air-cooled,
4-stroke, gasoline engine. Refer to Table 4 for engine
specifications.
WM70SLF/PLF PLASTER/MORTAR MIXERS • OPERATION MANUAL — REV. #0 (10/04/22) — PAGE 17
GENERAL INFORMATION
HARDWARE
Check all hardware on the mixer before starting. Periodically
inspect all hardware. Loose hardware can contribute
to early component failure and poor performance. Use
Table 5 as general guideline when the torquing of mixer
hardware is required. Remember to keep all mixer hardware
components tight.
Table 5. Hardware Torque
Recommendations
Hardware Diameter Torque (lbf·ft)
5/16" × 18
3/8" × 16
3/8" × 24
1/2" × 13
1/2" × 13 (Grade 8)
ENGINE MAINTENANCE
For basic engine maintenance, refer to the Engine
Maintenance section in this manual. For more detailed
engine maintenance, refer to the MPower engine owner's
manual provided with the engine.
OPTIONAL TOW BARS
The mixer can be configured for use with various types of
tow bars (ball, loop or pin). See Figure 8. Contact the MQ
sales department for the desired tow bar.
HBC-1
Figure 8. Optional Tow Bars
14
24
37
39
90
HLC-1
HPC-1
Advertisement
Table of Contents
