Removing The Door - Smeg SF64M3DS Instruction Manual

Cleaning the lower part
It is recommended that you clean and dry
the bottom of the oven after using the Direct
Steam function:
1. Remove in sequence, the perforated
cover (1), the evaporation tray (2) and
the bottom (3); lift the bottom by a few
millimetres and pull it outwards.
2. Carefully lift the end of the lower
heating element by a few centimetres
and clean the bottom of the oven.
3. Put the heating element back into its
seat when finished. Wait until the oven
cavity is completely dry before putting
back the accessories.
Cleaning and maintenance

4.3 Removing the door

For easier cleaning it is recommended to
remove the door and place it on a tea
towel.
To remove the door proceed as follows:
1. Open the door completely and insert two
pins into the holes on the hinges
indicated in the figure.
2. Grasp the door on both sides with both
hands, lift it so that it forms an angle of
around 30° and remove it.
3. To reassemble the door, put the hinges in
the relevant slots in the oven, making sure
that grooved sections A are resting
completely in the slots. Lower the door
57