Extraordinary Maintenance; Replacing The Light Bulb; Removing The Door - Smeg C6GVXI8-2 Manual

Table of Contents

10. EXTRAORDINARY MAINTENANCE

The oven requires periodic minor maintenance or replacement of parts subject to wear, such as gaskets,

light bulbs, etc. Specific instructions for each operation of this kind are given below.

Before any intervention that requires access to live parts, disconnect the appliance from the

power supply.

WARNING: For your safety, you are advised to wear protective gloves while performing any

cleaning or extraordinary maintenance.

If a light bulb needs to be replaced because it is worn

or burnt out, remove the guide frames; see "9.5.1

Removing guide frames (where present)".

Then remove the bulb cover using a tool (e.g. a

screwdriver).

Remove the bulb by unscrewing (filament bulbs) or

pulling it out (halogen bulbs) in the indicated direction.

Replace the bulb with one of the same type (25W for

filament bulbs or 40W for halogen bulbs).

Do not touch halogen bulbs directly with your fingers, wrap them in insulating material.

Open the door completely.

Insert a pin into the hole in the

hinge. Repeat for both hinges.

Instructions for the user

Grasp the door on both sides

with both hands, lift it forming an

angle of around 30° and remove it.

To reassemble the door, put the

hinges in the relevant slots in the

oven, making sure that grooved

sections C are resting completely

at the base of the slots. Lower

the door and once it is in place

remove the pins from the holes in

the hinges.

Table of Contents