Table of Contents
Advertisement
Problem
2. The message below appears.
Example:
5-2. Imaging Problems (for both digital and analog)
Problem
1. The screen is too bright or too dark.
2. Characters are blurred.
3. Afterimages appear.
4. Green / red / blue / white dots or
defective dots remain on the screen.
5. Interference patterns or pressure
marks remain on the screen.
6. Noise appears on the screen.
26
Chapter 5 Troubleshooting
Possible cause and remedy
This message appears when the signal is not input correctly even
when the monitor functions properly.
• The message shown left may appear, because some PCs do
not output the signal immediately after power-on.
• Check whether the PC is turned on.
• Check whether the signal cable is connected properly.
• Switch the input signal.
• Turn off the main power on the rear side of the monitor, and
then turn it on again.
• Check whether the PC is configured to meet the resolution
and vertical scan frequency requirements of the monitor (see
"Compatible Resolutions" (page
• Reboot the PC.
• Select an appropriate setting using the graphics board's utility.
For more information, refer to the User's Manual of the graphics
board.
Possible cause and remedy
• Use "Brightness" or "Contrast" in the Setting menu to adjust it.
(The LCD monitor backlight has a limited life span. If the screen
becomes dark or begins to flicker, consult your local EIZO
representative.)
• Check whether the PC is configured to meet the resolution
and vertical scan frequency requirements of the monitor (see
"Compatible Resolutions" (page
• When an image is displayed with a resolution other than
recommended, the characters or lines of the displayed image
may blur. Use "Smoothing" and "Screen Size" in the Setting
menu to adjust the display (see
"Screen Size" (page
19)).
• Afterimages are particular to LCD monitors.Avoid displaying the
same image for a long time.
• Use the screen saver or power save function to avoid displaying
the same image for extended periods of time.
• This is due to LCD panel characteristics and is not a failure.
• Display a white or black image over the entire screen. The
symptom may disappear.
• In the Setting menu, set "Overdrive" to "Off" (see
(page
18)).
• When entering the HDCP signals, the normal images may not
be displayed immediately.
35)).
35)).
"Smoothing" (page 19)
and
"Overdrive"
Advertisement
Table of Contents
