Table of Contents
Advertisement
5-2. Imaging Problems (For Both Digital and Analog)
Problem
1. The screen is too bright or too dark.
2. "Brightness" cannot be adjusted
• Cannot increase/decrease setting value ("
" is displayed in gray)
or "
- "Brightness" adjustment menu via
operation switch
- "Brightness" adjustment menu in color
adjustment
• Cannot increase/decrease setting value ("
" are displayed in gray)
and "
- "Brightness" adjustment menu via
operation switch
- "Brightness" adjustment menu in color
adjustment
3. Text is blurred
4. Afterimages appear
5. Green / red / blue / white dots or dark dots
remain on the screen.
6. Interference patterns or pressure marks
remain on the screen.
"
/
/
"
Possible cause and remedy
• Use "Brightness" or "Contrast" in the Setting menu to
adjust it (see
"Color Adjustment" (page
monitor backlight has a limited life span. If the screen
becomes dark or begins to flicker, contact your local EIZO
representative.)
• If the screen is too bright, try changing the Auto EcoView
setting to "On". The monitor detects the ambient
brightness to adjust the screen brightness automatically
(see
"Auto EcoView" (page
When Auto EcoView is set to "On", "Brightness" may not be
adjustable due to the advanced settings of Auto EcoView.
• The bright adjustment range of the Auto EcoView function
can be limited to ensure that the screen is neither too
bright nor too dark. When the adjustment range is limited,
values outside the range cannot be set. If you want to
set a value outside the range, try changing the following
settings.
- Change the maximum and minimum values for
"Brightness" in the Auto EcoView advanced settings.
- Set Auto EcoView to "Off".
For details on Auto EcoView settings, see
(page
14).
• Brightness adjustment may not be possible when the
installation environment of the monitor is excessively
bright or dark. In this case, try changing the following
settings.
- Change the maximum and minimum values for "Ambient
Light" in the Auto EcoView advanced settings.
- Set Auto EcoView to "Off".
For details on Auto EcoView settings, see
(page
14).
• Check whether the PC is configured to meet the resolution
and vertical scan frequency requirements of the monitor
(see
"1-3. Supported Resolutions" (page
• When an image is displayed with a resolution other than
recommended, text or lines in the displayed image may
blur. In this case, try adjusting "Sharpness" in the Setting
menu (see
"Sharpness" (page
• Afterimages are particular to LCD monitors. Avoid
displaying the same image for a long time.
• Use the screen saver or power saving function to avoid
displaying the same image for extended periods of time.
Depending on the image, an afterimage may appear even
if it was displayed for a short period of time. To remove
such a phenomenon, change the image or keep the power
turned off for several hours.
• This is due to LCD panel characteristics and not a
malfunction.
• Leave the monitor with a white or black screen. The
symptom may disappear.
18)). (The LCD
14)).
"Auto EcoView"
"Auto EcoView"
10)).
21)).
Chapter 5 Troubleshooting
29
Advertisement
Table of Contents
