Table of Contents
Advertisement
●
Analog Adjustment
Screen flickering, display position, and size can be adjusted when the D-Sub signal is input.
Function
Auto Screen Adjust
Auto Range Adjust
Clock
Phase
Hor. Position
Ver. Position
20
Chapter 4 Advanced Adjustment / Setting
Screen flickering, display position, and size can be adjusted automatically. Selecting
"Auto Screen Adjust" displays a message. Select "Yes" to enable this function.
Note
• The automatic screen adjustment function works correctly when an image is fully
displayed over the entire displayable area of the screen. They do not work properly
in the below cases:
- When an image is displayed only on a part of the screen (command prompt
window, for example)
- When a black background (wallpaper, etc.) is in use
Also, these functions cannot work properly in some graphic boards.
• When a signal is input into the monitor for the first time or when a resolution or
vertical / horizontal scan frequency not used before is set, the screen is adjusted
automatically (only for signals with a resolution of 800 × 600 or higher).
Every color gradation (0 to 255) can be displayed by automatically adjusting the signal
output level. Selecting "Auto Range Adjust" displays a message. Select "Yes" to enable
this function.
Flickering of vertical lines on the screen or part of the screen can be reduced.
Note
• Use
to make fine adjustments so as not to miss any adjustment points.
Flickering and blurring over the entire screen can be reduced.
Note
• Flickering or blurring may not be eliminated depending on your PC or graphics
board.
• After setting, adjust the "Clock" again if vertical bars appear.
The display position (horizontal and vertical) of the screen can be adjusted.
Note
• Since the number of pixels and the pixel positions are fixed on the LCD monitor,
only one position is provided to display images correctly. The position adjustment is
made to shift an image to the correct position.
Description
Advertisement
Table of Contents
