Table of Contents
Advertisement
Problem
Previously programmed
information is erased.
You cannot store a name
and phone number in the
directory.
While programming or
searching, the unit starts to
ring and stops the program/
search.
The unit does not display the
caller's name and/or phone
number.
The handset display exits
the Caller List.
When a second call is
received during a
conversation, the unit does
not display the new caller's
name and/or phone number.
You cannot page the
handset.
For assistance, please call: 1-800-211-PANA(7262)
Remedy
•If a power failure occurs, programmed
information may be erased. Reprogram
if necessary.
•You cannot store an item in the directory
while the unit is in the talk or speaker
mode.
•Do not pause for over 60 seconds while
storing.
•To answer the call, press
Start again from the beginning after
hanging up.
•You need to subscribe to a Caller ID
service.
•Other telephone equipment may be
interfering with your phone. Disconnect
it and try again.
•Other electrical appliances connected to
the same outlet may be interfering with
the Caller ID information.
•Telephone line noise may be affecting
the Caller ID information.
•Do not pause for over 60 seconds while
searching.
•The line mode selection is incorrect. See
page 15.
•The caller requested not to send his/her
information. See page 27.
•The handset is too far from the base unit.
•The handset is engaged in an outside
call, viewing the Caller List/directory list.
Wait until the IN USE/CHARGE/HOLD
indicator light goes out.
or
.
55
Advertisement
Table of Contents
