Omron sysmac FH Series Hardware Setup Manual page 63

Component Names and Functions
(A)
(B)
(C)
(D)
(E)
(F)
Connector name
(A) SD memory card
installation con-
nector
(B) Ethernet connec-
tor
(C) USB connector
(D) RS-232C connec-
tor
(E) DVI-I connector
(F) I/O(Parallel) con-
nector (control
lines, data lines)
(G) EtherCAT address
setup volume
(H) EtherCAT commu-
nication connec-
tor (IN)
(I) EtherCAT commu-
nication connec-
tor (OUT)
(J) Encoder connec-
tor
(K) Camera connec-
tor
(L) Power supply ter-
minal connector
Vision System FH/FZ5 series Hardware Setup Manual (Z366)
(G)
(H)
(I)
(J)
(K)
(L)
Install the SD memory card. Do not plug or unplug the SD memory card during
measurement operation. Otherwise measurement time may be affected or data
may be destroyed.
Connect an Ethernet device.
Camera 2ch type
Ethernet port and
EtherNet/IP port are
sharing use.
Connect a USB device. Do not plug or unplug it during measurement.
Measurement time might be affected otherwise.
Connect an external device such as a PLC.
Connect a monitor.
Connect the controller to external devices such as a sync sensor and PLC.
Used to set a station address (00 to 99) as an EtherCAT communication device.
Connect the opposed EtherCAT device.
Connect the opposed EtherCAT device.
Connect an encoder.
Connect cameras.
Connect a DC power supply. Wire the FH Sensor Controller independently on other
devices.
Wire the ground line. Be sure to ground the FH Sensor Controller alone.
Use an attachment power terminal (male) for installation.
For details, refer to 5-3-2 FH-1000/FH-3000 Series on page 5-8.
3 Configuration
Description
Camera 4ch/8ch type
Upper port :
Ethernet port
Lower port :
Ethernet port and
EtherNet/IP port are
sharing use.
3
3 - 5