Omron sysmac FH Series Hardware Setup Manual page 131

Touch Panel Cable
Use the USB cable for the connection cable of Touch Panel Monitor.
Use RS-232C cable for the connection cable of Touch Panel Monitor in the following cases.
• When the distance Touch Panel Monitor and FH Sensor Controller is 5 m or more.
• Cannot use the Touch Panel cable because the USB port of FH Sensor Controller is used for the
other I/O connection.
 Touch Panel Monitor Cables
Model
Cable type
Vibration resis-
tance
Ambient Tem-
perature
Ambient Humid-
ity
Ambient environ-
ment
Material
Minimum bend
radius
Weight
Vision System FH/FZ5 series Hardware Setup Manual (Z366)
FH-VMDA (2 m)
DVI-Analog Conversion
Cable
10 to 150 Hz, one-side amplitude 0.1 mm, 10 times for 8 minutes for each three direction
Operating Condition: 0 to 50°C,
Storage Condition: -10 to 60°C (with no icing or condensation)
Operating and Storage Condition: 35 to 85%RH
(with no icing or condensation)
No corrosive gases
Cable outer sheath, Connector: PVC
36 mm
Approx.220 g
FH-VUAB (2 m)
USB Cable
25 mm
Approx.75 g
3 Configuration
XW2Z-200PP-1 (2 m)
RS-232C Cable
Cable outer sheath: PVC,
Connector: ABS/Ni Plating
59 mm
Approx.162 g
3 - 73
3