Omron sysmac FH Series Hardware Setup Manual page 136

3 Configuration
Component Names and Functions
 Front View
 Rear
(5) MENU button
(6) + button
(7) - button
(8) AUTO button
(1) LED indicator lamp (for power)
(2) LED indicator lamp (for SYNC)
(3) Power connection terminal
(4) Video input (RGB)
(5) MENU button
(6) + button
(7) - button
(8) AUTO button
(9) VESA mounting hole (M4)
Wire
The power connection for the Touch Panel Monitor is on the back side of the Monitor.
Connect the 24 VDC power source.
24 VDC
Power
supply
24 VDC
• Keep the power supply wires as short as possible (maximum 10 m).
• If UL recognition is required, use a UL class II power supply.
Regarding installation, do not use the VESA mounting but fix the monitor unit using the board mount-
ing.
3 - 78
(1) LED indicator lamp (for power)
Display section
(4) Video input (RGB)
(3) Power connection
terminal
Name
Lit up green when power is ON.
Lit up orange while the video signal is input.
Connect power unit for 24 VDC.
Video input terminal (RGB)
OSD operating button (MENU button)
OSD operating button (+ button)
OSD operating button (- button)
OSD operating button (AUTO button)
Mounting hole for VESA 75 mm × 75 mm
M3
(Outside diameter of crimp terminal:
Dia 5.5 mm maximum)
RGB
Recommended model
OMRON Corporation-manufactured
S8VS-03024
(2) LED indicator lamp
(for SYNC)
(9) VESA mounting
hole (M4)
Description
Vision System FH/FZ5 series Hardware Setup Manual (Z366)