Omron sysmac FH Series Hardware Setup Manual page 133

Wiring
The power connection for the Touch Panel Monitor is on the back side of the Monitor.
Connect the 24 VDC power source.
24 VDC
Power supply
24 VDC
• Keep the power supply wires as short as possible. (Max.2 m)
• If UL's certification is required, use a UL class II power supply.
• Use the cables and crimping terminals with the specified dimensions.
Do not directly connect an electric wire that is simply twisted to the terminal block.
• Recommended wire size: AWG 13 to 22 (0.326 to 2.62 mm
• Terminal screw: M4 (Tightening torque: 1.0 N•m)
• Crimping Terminal
8.0 mm max.
Dimensions
26 270
7.74 306.52
322
161
180
Note 1. Panel thickness: 1.6 to 4.8 mm
2. No burr allowed
Vision System FH/FZ5 series Hardware Setup Manual (Z366)
M4
Recommended model
by OMRON:
S8VS-03024
8.0 mm max.
26
7.74
8-M4 Effective
screw length6
Mounting plate
(19) thickness 1.6-4.8
3 Configuration
2
)
100
Panel cutout dimensions
75
37.5
3
+1
307
0
3 - 75