Table of Contents
Advertisement
PC IN terminal connection
(Female)
DIGITAL LINK
(Male)
Mini D-sub 15p cable (commercially available)
Conversion adapter (if necessary) (commercially
available)
Stereo mini plug (M3) cable (commercially available)
PC
The type of computer signal that can be connected
●
With regard to the typical PC input signals that
are described in "Preset Signals" (see page 123),
adjustment values such as for the standard picture
positions and sizes have already been stored in this
unit.
(Computer signals which can be input are those with
a horizontal scanning frequency of 30 to 110 kHz and
vertical scanning frequency of 48 to 120 Hz.)
●
The display resolution is a maximum of 1 440 x 1 080
dots when the aspect mode is set to [4:3], and 1 920
x 1 080 dots when the aspect mode is set to [16:9].
If the display resolution exceeds these maximums, it
may not be possible to show fine detail with sufficient
clarity.
●
In [ENGLISH(US)] OSD language, [16:9] is displayed
as [FULL].
●
If signals outside the range of supported frequencies
are input, normal images cannot be displayed. Note
that some images may not be correctly displayed
even if signals are within the range.
●
●
Connect a cable
which matches
●
the audio output
terminal on the
●
computer.
(commercially
available)
●
●
●
Pin assignments and signal names for PC Input
Terminal (Mini D-sub 15P)
If the PC screen is not displayed, check if the image
signal of the PC meets "Preset Signals" (see page
123), and then change the settings. For power-saving
purpose, image output may be OFF on a notebook
computer. In this case, it may be set to ON with
function key operation etc. of the computer. (Refer to
the manual of the computer.)
Note
Component video signal is supported with this
terminal (Mini D-sub 15P). Change the [Component/
RGB-in select] setting in the [Signal] menu to
[Component] (when Component signal connection) or
[RGB] (when RGB signal connection). (see page 48)
Additional computer, cables and conversion adapter
shown are not supplied with this set.
If the computer being connected is not DDC2B-
compatible, you will need to make setting changes to
the computer at the time of connection.
When connecting a computer equipped with a
D-sub15 pin terminal or a Mac, use a commercially
sold conversion adapter as necessary.
There is no need to use an adapter for computers
*
with DOS/V compatible Mini D-sub 15P terminal.
Do not set the horizontal and vertical scanning
frequencies for PC signals which are above or below
the specified frequency range.
Audio input is shared with AV IN terminal.
5
4
3
10
9
15 14 13 12 11
Pin No.
R (P
/C
R
R
G (Y)
B (P
/C
B
B
NC (not connected)
GND (Ground)
GND (Ground)
GND (Ground)
GND (Ground)
+5 V DC
GND (Ground)
NC (not connected)
SDA
HD/SYNC
VD
SCL
2
1
8
7
6
Signal Name
)
)
English
21
Advertisement
Table of Contents
