Pc In Terminal Connection - Panasonic TH-75BQ1W Operating Instructions Manual

PC IN terminal connection

(Female)
(Male)
Mini D-sub 15p cable (commercially available)
Stereo mini plug (M3) cable (commercially available)
PC
The type of computer signal that can be connected
●
With regard to the typical PC input signals that
are described in "Preset Signals" (see page 155),
adjustment values such as for the standard picture
positions and sizes have already been stored in this
unit.
(Computer signals which can be input are those with
a horizontal scanning frequency of 30 to 110 kHz and
vertical scanning frequency of 48 to 120 Hz.)
●
The display resolution is a maximum of 1 440 x
1 080 dots when the aspect mode is set to [Normal],
and 1 920 x 1 080 dots when the aspect mode is
set to [Full]. If the display resolution exceeds these
maximums, it may not be possible to show fine detail
with sufficient clarity.
●
If signals outside the range of supported frequencies
are input, normal images cannot be displayed. Note
that some images may not be correctly displayed
even if signals are within the range.
●
If the PC screen is not displayed, check if the image
signal of the PC meets "Preset Signals" (see page
155), and then change the settings. For power-saving
purpose, image output may be OFF on a notebook
computer. In this case, it may be set to ON with
function key operation etc. of the computer. (Refer to
the manual of the computer.)
●
●
●
Connect a cable
which matches
the audio output
●
terminal on the
computer.
(commercially
●
available)
Pin assignments and signal names for PC Input
Terminal (Mini D-sub 15P)
Note
Component video signal is supported with this
terminal (Mini D-sub 15P).
Change the [Component/RGB-in select] setting in
the [Signal] menu to [Component] (when Component
signal connection) or [RGB] (when RGB signal
connection). (see page 79)
Additional computer, cables and conversion adapter
shown are not supplied with this set.
If the computer being connected is not DDC2B-
compatible, you will need to make setting changes to
the computer at the time of connection.
Do not set the horizontal and vertical scanning
frequencies for PC signals which are above or below
the specified frequency range.
For audio, the AUDIO IN 1 / AUDIO IN 2 terminal can
be used. (For [Audio input select] function, see page
91.)
5 4 3
10 9
15 14 13 12 11
Pin No.
R (P /C
R R
G (Y)
B (P /C
B B
NC (not connected)
GND (Ground)
GND (Ground)
GND (Ground)
GND (Ground)
+5 V DC
GND (Ground)
NC (not connected)
SDA
HD
VD
SCL
2 1
8 7 6
Signal Name
)
)
English
23