Installing An Internal Usb Device - HP ProLiant ML30 Gen10 User Manual

Installing an internal USB device

Installing an internal USB device
Procedure Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. Do one of the following:
If the server is in tower mode: Position the tower server for hardware configuration.
If the server is in rack mode: Remove the server from the rack .
5. Remove the front bezel .
6. Remove the access panel .
7. If installed, remove the air baffle .
8. Locate the internal USB connector.
9. Plug in the USB device into the internal USB port.
10. If removed, install the air baffle .
11. Install the access panel .
12. Install the front bezel .
13. Do one of the following:
If the server is in tower mode: Position the tower server for operation .
If the server is in rack mode: Install the server on the tray .
14. Connect all peripheral cables to the server.
15. Connect the power cords:
a. Connect each power cord to the server.
Installing an internal USB device 139