Installing An M.2 Nvme Ssd On An M.2 Ssd/Dedicated Ilo/Serial Port Enablement Board - HP ProLiant ML30 Gen10 User Manual

Installing an M.2 NVMe SSD on an M.2 SSD/dedicated iLO/serial port enablement board

Installing an M.2 NVMe SSD on an M.2 SSD/dedicated iLO/serial port enablement board
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have the following tools available:
T-15 Torx screwdriver
4.5 mm hex nut screwdriver
Phillips No. 1 screwdriver
Procedure Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. Do one of the following:
If the server is in tower mode: Position the tower server for hardware configuration.
If the server is in rack mode: Remove the server from the rack .
5. Remove the front bezel .
6. Remove the access panel .
7. If installed, remove the air baffle .
8. Install the M.2 SSD/dedicated iLO/serial port enablement board .
9. Identify the appropriate standoff position and install the hex nut.
10. Install the M.2 SSD:
a. Insert the SSD into the M.2 slot at a 45° angle.
b. Carefully press the SSD down to the horizontal position.
c. Install the SSD mounting screw.
Installing an M.2 NVMe SSD on an M.2 SSD/dedicated iLO/serial port enablement board 121