Installing The M.2 Ssd/Dedicated Ilo/Serial Port Enablement Board - HP ProLiant ML30 Gen10 User Manual

Installing the M.2 SSD/dedicated iLO/serial port enablement board

Installing the M.2 SSD/dedicated iLO/serial port enablement board
Prerequisites Prerequisites
Before you perform this procedure, make sure that you have the following tools available:
T-15 Torx screwdriver
4.5 mm hex nut screwdriver
Procedure Procedure
1. Power down the server.
2. Remove all power:
a. Disconnect each power cord from the power source.
b. Disconnect each power cord from the server.
3. Disconnect all peripheral cables from the server.
4. Do one of the following:
If the server is in tower mode: Position the tower server for hardware configuration.
If the server is in rack mode: Remove the server from the rack .
5. Remove the front bezel .
6. Remove the access panel .
7. If installed, remove the air baffle .
8. Remove the Phillips screw and the hex nut.
9. Remove the iLO dedicated network port blank.
Installing the M.2 SSD/dedicated iLO/serial port enablement board 109