Individual Setting - Fujitsu AIRSTAGE UTY-DCGYZ2 Operation Manual

2-2-2. Individual Setting


5
4

9


No. Item
"Group name" / "R.C.G. name"

"Special State"

"Room Temp."
3
"On/Off"
4
"Mode"
5
"Set Temp."
6
"Set Temp. (Custom Auto)" "Cool"*
7
"Set Temp. (Custom Auto)" "Heat"*
8
"Fan Speed"
9
"Air Flow Direction"

"Anti Freeze"

"Economy"

"Temp. Limit"

"Filter Sign"

"R.C. Prohibition"

"Human Sensor"

Group / R.C.G. switch-over button

* "Set temp." is displayed only when a unit with Custom Auto function is registered.
Note
Custom Auto:
Set the set temperature for cooling and the set temperature for heating separately. During the Custom Auto mode
operation, when the room temperature exceeds the set temperature for cooling, the cooling operation is performed, and
when the room temperature falls below the set temperature for heating, the heating operation is performed. (It can be
used only when the setting of the indoor unit compatible with this function is valid.)
En-18

3
6
7




Selects "Group name" to be set.
For Batch setting, "All Indoor Units" is displayed.
When the currently displayed group or R.C.G. is in a special state, icon is
displayed.
• Displayed states when even one unit is in a special state
• Displayed state when all units are in a special state
Managed unit (when all indoor units are not master indoor unit, and
master unit is managed or outdoor unit is managed)
Displays the room temperature.
Selects "On" or "Off" for operation state.
Selects the mode. ("Auto", "Cool", "Dry", "Fan" and "Heat". Selectable
mode depends on the indoor unit)
Selects the "Set Temp." with 0.5ºC (1ºF) in units. (except when "Fan" or
"Off" is selected)
Selects the "Set Temp." during "Cool" operation and the "Set Temp."
during "Heat" operation when operation mode is "Custom Auto". (Applied
indoor unit and non-applied outdoor unit cannot bemixed.)
Sets "Fan Speed".
"Auto", "High", "Med-High", "Med", "Med-Low", "Low", "Quiet"
Sets "Air Flow Direction". → Refer to 2-2-2-1.
Sets "Anti Freeze" operation. Select "On" or "Off".
Sets "Economy" operation. Select "On" or "Off".
Sets "Temp. Limit". → Refer to 2-2-2-2.
Resets "Filter Sign". (Operation accumulated time is reset.)
Sets "R.C. Prohibition". → Refer to 2-2-2-3.
Sets "Human Sensor". → Refer to 2-2-2-4.
Switches over between group display and R.C.G. display.
8
Icon State
Emergency stop
Maintenance mode
Refrigerant leakage
Error
Defrost
Oil recovery
Description
Icon State
Mismatch mode
Master controlled
Test operation
Pump down
Auxiliary power supply
― ―