Basic Troubleshooting - Pride Mobility Zero Turn 10 Owner's Manual

V I I . B A S I C T R O U B L E S H O O T I N G
Any electromechanical device occasionally requires some troubleshooting. However, most of the problems that
may arise can usually be solved with a bit of thought and common sense. Many of these problems occur because
the batteries are not fully charged or because the batteries are worn down and can no longer hold a charge.
DIAGNOSTIC CODES
The diagnostic codes for your scooter are designed to help you perform basic troubleshooting quickly and easily. A
diagnostic code will sound and/or fl ash in the event one of the conditions listed below develops. Depending on the
model you own, your scooter will communicate by one of the coding methods as follows:
1. A diagnostic code will begin, depending on model, with a series of fast beeps and/or fl ashes directly followed
by slower beeps and/or fl ashes which indicates the actual code. The code is only beeped and/or blinked once.
To repeat the diagnostic code, remove the key, then reinsert it and turn it to the "on" position, OR
2. A diagnostic code will identify the condition, pause, then repeat the code. The diagnostic code will continue
to alert you in this manner until the scooter is turned off .
NOTE: Your scooter will not run unless the code condition is resolved and the scooter has been turned off , then
turned back on.
BEEP CODE
■
(1)
■■
(2)
■■■
(3)
■■■■
(4)
■■■■■
(5)
■■■■■■
(6)
■■■■■■■
(7)
■■■■■■■■
(8)
■■■■■■■■■
(9)
Figure 28. Models with Tiller Console
34
CONDITION
Battery charge is too low to operate the scooter. Charge batteries as soon as possible.
Battery charge is too low.
The scooter's battery voltage is too high to
operate the scooter, or the charger is still
connected to the off -board charger port.
Current limit time out.
The manual freewheel lever is in the freewheel
position.
Throttle control lever not at center position at
start up.
Speed pot error.
Motor volts error.
Other internal errors.
SOLUTION
Charge batteries.
Unplug charger and/or turn key off , then back
on again.
Turn the scooter off for a few minutes, then turn
your scooter back on.
Remove the key from the key switch, then push
the manual freewheel lever to the drive position
and restart your scooter.
Verify that the batteries are fully charged. If
the batteries are fully charged, then return the
throttle control lever to center position, turn
scooter off then back on.
Contact your authorized Provider for assistance.
Contact your authorized Provider for assistance.
Contact your authorized Provider for assistance.
Mid-size Scooter Series