Table of Contents
Advertisement
V I I I . B A S I C T R O U B L E S H O O T I N G
Any electromechanical device occasionally requires some troubleshooting. However, most of the
problems that may arise can usually be solved with a bit of thought and common sense. Many of these
problems occur because the batteries are not fully charged or because the batteries are worn down and
can no longer hold a charge.
DIAGNOSTIC BEEP CODES
The diagnostic beep codes for your scooter are designed to help you perform basic troubleshooting
quickly and easily. A diagnostic beep code will sound in the event one of the conditions listed below
develops.
NOTE: Your scooter will not run unless the beep code condition is resolved and the scooter has
been turned off, then turned back on.
BEEP CODE
(1)
(2)
(3)
(4)
(5)
(6)
(7)
(8)
(9)
24
CONDITION
Battery charge is low.
Battery charge is too low.
The scooter's battery voltage is
too high to operate the scooter,
or the charger is still connected to
the offboard charger port.
Current limit time out.
The manual freewheel lever is in
the freewheel (forward) position.
Throttle control lever not at center
position at start up.
Speed pot or throttle control error. Contact your authorised Pride
Motor volts error.
Other internal errors.
SOLUTION
Charge batteries as soon as
possible.
Charge batteries.
Unplug charger and/or turn key off,
then back on again.
Turn the scooter off for a few
minutes, then turn your scooter
back on.
Remove the key from the key switch,
then push the manual freewheel
lever
to
the
drive
position, and restart your scooter.
Return the throttle control lever to
centre position, turn scooter off
then back on.
Provider for assistance.
Contact your authorised Pride
Provider for assistance.
Contact your authorised Pride
Provider for assistance.
(rearward)
- Quick Links:
- Batteries and Charging
Hide quick links:
Advertisement
Table of Contents
