Basic Troubleshooting; Diagnostic Fault Codes - Pride Mobility 614 Owner's Manual

V I I . B A S I C T R O U B L E S H O O T I N G
Any electromechanical device occasionally requires some troubleshooting. However, most of the problems that
may arise can usually be solved with a bit of thought and common sense. Many of these problems occur because
the batteries are not fully charged or because the batteries are worn down and can no longer hold a charge.

DIAGNOSTIC FAULT CODES

The diagnostic beep codes for your scooter are designed to help you perform basic troubleshooting quickly and
easily. A diagnostic fl ash code will fl ash from the status LED in the event one of the conditions listed below
develops. See fi gure 25 or 26.
NOTE: Your scooter will not run unless the fault code condition is resolved and the scooter has been turned
off, then turned back on.
FAULT CODE
■
(1)
■■
(2)
■■■
(3)
■■■■
(4)
■■■■■
(5)
■■■■■■
(6)
■■■■■■■
(7)
■■■■■■■■
(8)
■■■■■■■■■
(9)
Figure 25. Models with Tiller Console
What if all the systems on my scooter seem to be dead?
 Make certain that the key is in the "on" position.
 Check that the batteries are fully charged.
 Push in the main circuit breaker reset button. See II. "Your Scooter."
 Make certain that both battery harnesses and the front-to-rear harness are fi rmly connected.
 Be sure the power down timer feature has not been activated. See IV. "Operation."
34
CONDITION
Battery charge is low.
Battery charge is too low.
The scooter's battery voltage is too high to
operate the scooter, or the charger is still
connected to the off-board charger port.
Current limit time out.
The manual freewheel lever is in the (forward)
freewheel position.
Throttle control lever not at center position at
start up.
Speed pot error.
Motor volts error.
Other internal errors.
SOLUTION
Charge batteries as soon as possible.
Charge batteries.
Unplug charger and/or turn key off, then back
on again.
Turn the scooter off for a few minutes, then turn
your scooter back on.
Remove the key from the key switch, then
push the manual freewheel lever to the drive
(rearward) position and restart your scooter.
Verify that the batteries are fully charged. If
the batteries are fully charged, then return the
throttle control lever to center position, turn
scooter off then back on.
Contact your authorized Provider for assistance.
Contact your authorized Provider for assistance.
Contact your authorized Provider for assistance.
Full-size Scooter Series