System Programming And Diagnosis With Personal Computer - Panasonic KX-TD816NE Features Manual

1.1 General Features
System Programming and Diagnosis with
Personal Computer
Description
This system can be programmed and administered using a personal computer. EIA / Remote
Programming & Diagnosis Manual and its floppy is required to perform this feature. There are
two programming methods:
On-Site Programming
By connecting a personal computer (PC) to your system, system programming and
maintenance
(Method 1.) Using the Serial Interface (RS-232C) port Connect the PC to the Serial Interface
(RS-232C) port provided. The main unit has a Serial Interface (RS-232C) port which can be
used for either system administration or SMDR.
(Method 2.) Using a modem
Install the optional Remote Card or Unit. Connect the PC to an extension jack. Assign the
floating number of the modem in System Programming. Dial this number from the PC.
Remote Programming
You can perform system programming and maintenance from a remote site using a PC. Install
the Remote Card / Unit and assign the floating number of the modem in System Programming.
Starting system administration from a remote location can be done in the following ways.
• Call an extension (probably the Operator) from a remote location and request a transfer
to the modem.
• Assign the modem as the destination of the DIL 1:1 feature.
Conditions
• A proprietary telephone can be used to perform System Programming.
• Only one access is allowed to System Programming at any one time.
• To access system administration, a valid password must be entered. The password is
factory-programmed and can be changed.
• System administration can be performed on-line except for the procedures of diagnosis.
Installation Manual References
• 2.4.8 Remote Card Installation
• 2.4.9 9600bps Speed Remote Unit / Message Unit Installation
• 2.4.10 9600bps Speed Remote Card / Message Card Installation
Available for the KX-TD1232 only.
*1
Available for the KX-TD1232 only.
*2
Available for the KX-TD1232 only.
*3
220
can be performed locally. There are two ways available to perform the above:
*1
*2
*3
Features Guide