Panasonic KX-TD816NE Features Manual page 211

8.
Cost : shows the amount of charge fee; Unit or DM.
9.
Acc Code : shows the account code appended to the call.
If the Private Call is made, "11111" is shown as a code.
10.
CD : shows the condition code.
T :Transfer
F :Call Forwarding to CO line
M : Remote Maintenance (MODEM)
R : Receive an incoming call
A : Answer an incoming call
N : No answer an incoming call
D : Doorphone Call Forwarding to CO line
11.
Ring: shows the ring duration of the incoming call as Minutes / Seconds.
Conditions
• When programmed for outgoing toll calls only, printing occurs only for calls which start
with the numbers stored in any Denied Code Table from levels 2 to 6.
• This system can store information on up to 100 calls. If more calls are initiated or received,
stored records are deleted starting from the oldest one.
• It is possible to select the SMDR format, page length, skip perforation and page width. If
80 characters for page width is selected, the last five digits of account codes are not printed
out.
• This data is not deleted when you reset the system.
• "8. Cost" is printed out in the format selected in programme [117] "Charge Display
Selection."
• It is programmable to enable or disable the printout of secret dial numbers.
• If the account code stored in location 001 of the programming table is dialled, the dialled
number is not printed out to SMDR (Private Call). Refer to the seven and eight lines on an
example of printed call records.
• When the paper of the printer runs out or the printer is out-of-service, the indication "Check
Printer" is displayed on the telephone of Operator 1.
Installation Manual References
• 2.3.10 Printer Connection
Programming Guide References
• [000] Date and Time Set
• [800] SMDR Incoming / Outgoing Call Log Printout
• [801] SMDR Format
• [802] System Data Printout
• [806-807] Serial Interface (RS-232C) Parameters — Port 1 / Port 2
• [990] System Additional Information
Available for the KX-TD1232 only.
*1
Features Guide
*1
1.1 General Features
211