Advanced Connections - JVC GR-DLS1 Instructions Manual

60
EN
Connection To A Personal Computer
This camcorder can transfer still images to a personal computer by using the provided software when
connected as shown in the illustration below. It is also possible to transfer still images to a personal compu-
ter with a DV connector-equipped capture board installed.
Core filter
1 CO N FIRM PO W ER-O FF STATUS
Make sure the camcorder and PC are turned
off.
2 CO N N ECT CAM CO RDER TO PC
Pull out the connector cover and open it.
Connect the camcorder to a PC using the cable
according to your PC type as shown in the
illustration.
SUPPL Y PO W ER
3
Connect the camcorder to the AC Power
Adapter/Charger using the DC cord, then plug
the AC Power Adapter/Charger's power cord
into an AC outlet.
Downloaded from:
To DV O U T
connector
To AC outlet
To D C IN
jack
D C cord
https://www.usersmanualguide.com/
PLAYBACK
JLIP (D IGITAL STILL)
output connector
Core filter
JLIP-PC connection cable
(provided)
DV cable (optional)
VC-VDV204U
Core filter
AC Power
Adapter/ Charger
(provided)
To D C O U T jack
4 TURN O N PO W ER
Turn the camcorder's Power Dial to "PLAY"
while pressing down the lock button located
on the dial and turn on the PC.
N O TES:
● W hen transferring still images, never use the
battery pack installed in the camcorder as the
power supply. U se the provided AC Power
Adapter/ Charger.
●
N ever connect the JLIP-PC connection cable and
the DV cable simultaneously to the camcorder.
Connect only the cable you wish to use to the
camcorder.
● The date/time information cannot be captured into
PC.
● Also refer to the instruction manuals of the provided
Software and the DV connector-equipped capture
board.

Advanced Connections

To RS-232C
PC
To DV
connector
PC with DV
connector-
equipped
capture board