Pro-Form Sport E5.0 User Manual page 7

3. If there is a shipping tube (not shown) attached
to the Frame (1), remove the screws (not shown)
and then remove the shipping tube. Discard the
screws and the shipping tube.
Orient the Front Stabilizer (3) so that the sticker
is facing away from the front of the Frame (1).
With the help of a second person, place some
of the packing materials (not shown) under the
front of the Frame (1).
Tip: Make sure to lift the Pedal Arms (16, 17)
above the Front Stabilizer (3) before you
attach it. Attach the Front Stabilizer to the
Frame (1) with two M10 x 82mm Screws (70).
Then, remove the packing materials from under
the front of the Frame (1).
4. Have a second person hold the Upright (2) near
the Frame (1) as shown.
See the upper inset drawing. Locate the wire
tie (A) in the lower end of the Upright (2). Tie
the wire tie to the Main Wire (89). Then, pull the
upper end of the wire tie until the Main Wire is
routed through the Upright.
Tip: To prevent the Main Wire (89) from falling
into the Upright (2), secure the Main Wire
with the wire tie (A).
See the lower inset drawing. Tip: Avoid
pinching the Main Wire (89). Have a second
person hold the Upright (2) on the Frame (1).
Tip: Two M8 x 15mm Screws (60) are
preattached to the Frame (1).
Attach the Upright (2) with two M8 x 25mm
Screws (92); do not fully tighten the
Screws yet.
3
16
4
A
2
1
7
17
70
3
1
2
A
89
2
92
92
89
1
60