Kyocera ECOSYS PA6000 Series Operation Manual page 58

Installing and Setting up the Machine > Network Setup
6
Configure the handheld device.
1 [Settings] > [Wi-Fi]
2 Select the network name (SSID) appeared in step 5 from the list.
3 Enter the password that was provided in step 5 > [Connect]
The network between this machine and the handheld device is configured.
Configuring the Connection by Using Push Button
When your computer or handheld device does not support Wi-Fi Direct but supports WPS, you can configure the
network using push button.
1
Display the screen.
[Menu] key > [ ] [ ] key > [Network] > [OK] key > [ ] [ ] key > [Wi-Fi Direct Set] > [OK] key > [ ] [ ] key >
[Wi-Fi Direct] > [OK] key
2
Configure the settings.
[ ] [ ] key > [On] > [OK] key
3
Restart the network.
[Menu] key > [ ] [ ] key > [Network] > [OK] key > [ ] [ ] key > [Restart Network] > [OK] key > [Yes]
4
[Status] key > [ ] [ ] key > [Wi-Fi Direct] > [OK] key > [PushButton Setup] > [OK] key
5
Press the push button on the computer or handheld device and select [Push Button]
on the screen of operation panel simultaneously > [Next].
The network between this machine and the computer or handheld device is configured.
IMPORTANT
You can connect up to 10 handheld devices at the same time using Wi-Fi Direct setting. When the
devices that support Wi-Fi Direct are connected, if you want to connect other device, disconnect the
already-connected devices from the network. The disconnection methods are as follows:
• Disconnect the network from the computer or handheld computer
• Disconnecting all devices from the network on the operation panel
Select [Wi-Fi Direct] key > [ ] [ ] key > [ConnectionStatus] > [OK] key > [Menu] > [ ] [ ] key >
[Disconnect All] > [OK] key
• Configuring auto disconnecting time from the System menu
Wi-Fi Settings (page 8-16)
• Configuring auto disconnecting time from the Command Center RX
Command Center RX User Guide
2-25