Kyocera ECOSYS PA6000 Series Operation Manual page 200

Setup and Registration (System Menu) > Operation Method
Item
DataSanitization
Run Immediately
Schedule
Device Use
SW Verification
Manual FW Update
[Menu] key > [ ] [ ] key > [Security] > [OK] key > [ ] [ ] key > [Manual FW Update] > [OK] key
Item
Manual FW Update
Return the following information registered in the machine to the factory defaults.
• System settings
• Data saved in Custom Box
• Optional applications
IMPORTANT
Data saved in an application or SD card cannot be erased. To erase data on an SD
card, you must format the SD card.
Format SD Card (page 8-33)
NOTE
• Once in progress, the processing cannot canceled.
• Before executing this function, disconnect modular, network, and other cables.
• Before performing this function, set all interface block settings to [Unblock].
I/F Block Set. (page 8-39)
• Do not turn off the main power switch while sanitizing the data. If the main power is
turned off during data erasing, erasing will be executed automatically when the
power is restored, however, complete erasure cannot be guaranteed.
Data Sanitization will be performed.
Completely erase address and image data saved in the device at the scheduled time.
Value: Off, On
If [On] is selected, set the date and time that sanitization is to be performed. The setting
range is Year (2000 to 2037), Month (1 to 12), Day (1 to 31), Hour (00 to 23).
The device use restriction after the data sanitization is completed.
The device cannot be used if [Prohibit] is selected.
Value: Permit, Prohibit
Verify the software in the machine.
Select [Execute] to start verification. If you experience any abnormalities in software
verification, contact your service representative.
Set whether to allow firmware updates.
Value: Off, On
8-41
Description
Description